Radio Control Couplings for model flight
Motors and Grearboxes
Batteries and Charges
Couplings and Clutches
Propellers and Adapters
Pico Stick
Accessories
Links
e-mail us
Home Page

Privacy Policy

Radio Control Couplings

In certain applications where you would wish to mount the electric motor further back
from the nose of the model, you need a propeller shaft, and coupling (rigid or universal) to
transmit the drive. Two typical instances come to mind, both of which we have succesfully
built and flown very well.
Radio Control Couplings
Rubber model "Majestyk" by Campbells custom kits, span increased to 34", all up weight 6oz. Any of the "KeilKraft" or "Veron" rubber Freeflight kits 30" span and above would also be perfect, as would many of the "Wakefield" class.
Couplings
We fitted 8 - 50 ma Sanyo cells, GWS Micro RX, Jeti 050 ESC and brake, 2 Hitec Feather servos 9" folding propeller.
Total weight was 6oz, complete with motor 7:1 gearbox. Trimmed to circle gently RH under power in 20/25 or 30 metre circles, gentle climb up to approx 150/200 ft takes around 11/2 minutes.
Typical flight sequence - Switch power off & transition into glide is smooth, & still in RH turns, which
open up to about 50 metre circles. Any tendancey for model to drift out of the cricket pitch or similar, was
corrected by one or two gentle dabs of rudder.
We get 2 good burns from each charge of our yellow Sanyo cells, IE 1st from hand launch & up
to +150 ft glide down to 30 or 40 ft, power on again back up to 150ft glide again down to say 40/50 ft, take
control and land.
Best flight so far, 10 mins 28 seconds 95% of which was "Freeflight".

Radio Control Radio Control Couplings
The above info also applies to our model of the 38" span "Gladiator" pictured here. All up weight 71/4 oz other models such as "Scram", "the Answer", "Brigadeer" etc would work well at around 38 / 40" span,
BUILD LIGHT !!

Parts available : for F.F. Rubber conversions.

1 - Prop shafts complete with bearings, prop driver and spinner.

2 - Couplings rigid and universal

3a - On special order, complete nose block assemblies complete with shaft, prop driver and
spinner, rubber model style coupling or universal.

3b - As in 3a + motor and gearbox.
Note !! For 3a & 3b we would need full details of your model.

4 - Motors and gearboxes.

5 - Folding propellers 8" and 9" (plastic).

6 - Old style wooden props (optimised for electric flight).
Since variation is so wide in shaft and gearbox sizes prices available on request

7 - Dummy spark/Diesel motors, to give the
"Vintage" model the "Vintage" look. See our accessories page.

All Rights Reserved © Copyright CleanSwing.